Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (December 1995)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 30 Dec 1995 23:01:55 -0500
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         dlm202@psu.edu (Dave Mancuso)
Subject:      Update on drain Plug (stripped)

So, there's still a slow leak (a drop every once in a while). Possible causes: 1) new bolt not tight enough (I was afraid to put any pressure on it). 2) I used two copper washers instead of one, because the new bolt is a millimeter or so longer than the old one (should I be concerned about this length?). 3) the newly threaded hole just isn't strong enough 4) something else I haven't thought of.

Solutions: I'm going to reinstall the plug bolt using a nylon washer, which should form a better seal than the copper ones that VW has been giving me. The washer is made for this kind of application, so it should be OK. If it still doesn't work, I have a rubber expansion bolt as Bob described in his sermonette (thank you Bob!). I hate to use a solution like that (it _seems_ like such a temporary measure), but it'll do until I find a better solution.

Possible original causes of my problem (what did I do wrong): 1) I don't think I used too much torque on the bolt during my oil changes, but since I haven't used torque wrenches to tighten this bolt, I can't really claim any exact torque figures. I tend to use a six inch socket wrench and hold it close to the neck. I'd say I tightened it to 15-18 ft. lbs. at most, but that guesstimate's worth zip in the absence of an actual measurement. 2) (this is the biggie) You may gasp in horror at my stupidity, but I'd always been taught to warm up the engine a little to get any gunk up into the oil (so it drains out with the oil). I'd always wondered about this, but it always worked. However, warming up an aluminum engine and then pulling a bolt out of a warm crankcase may win me new honors in the "no-brainer" department--literally. This theory may be supported by the fact that the bolt stripped coming out of the case--not going back in. 3) I've been using new copper washers, but Bob's sermonette reminded me of the old crushable washers I used to use on my 412's (Type IV engines in Type IV bodies--what a concept). Maybe these washers contributed to my problem, although they are what's sold at the dealer. I haven't seen the crushable kind for years around here.

Hmmmm. Hope this helps someone on the road to a similar mistake,

Dave

===================================== dlm202@psu.edu Dave Mancuso

'87 Vanagon (Kalypso) '89 Jetta


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.