>I have a 34PICT3 carb and 009 distributor. I want to trade out for the >vacuum advanced distributor that was intended for the '71/34pict setup. >Can someone please inform me regarding the setup for the vacuum lines? >There are four vacuum (two with tubes; two without) outlets on the carb and >only one on the distributor. > >Thanks! Joe > >I swapped my 009 for a stock dist. on my 71 bus. On my dist. there are two vacuum connects on the round can. One points towards you as you face the engine and the other points toward the fan housing. The one that points towards you is connected to the carb on the left side next to the large idle screw. The other line goes to connection on the carb that faces you and is about level/even with the middle of the return spring. Hope that helps. Martin
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.