>Maybe You can help me with mine then.. I replace the float on mine, >replaced the fuel gauge and voltage stablizier, and still refuses to >work.. but, if I take the float out of the tank and ground the top of the >sender, I can make it work just fine.. So I figured, bad ground, right? >So I did the same thing when it was in the tank, and still wouldn't >work.. It would just always read full... :( If it reads full I think that means there is a ground somewhere where there shouldn't be, like you say. Have you checked the circuit with a multimeter? If it all checks out OK, maybe something's obstructing the float when it's in the tank.
Andy E. A.C.Erskine@lut.ac.uk
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.