In a message dated 96-02-06 16:07:46 EST, kstanley@cas.org writes: > When I took >the trans out to replace the input seal, I noticed the pilot bearing in the >flywheel/crankshaft was non-existant. With the bearing gone the input shaft >wobbled around and destroyed the input seal. I now attribute the poor clutch >action to be the input shaft binding up a little in the self destructing >needle bearing. I had a pilot bearing on an Audi 100LS that seized so tightly that the clutch engagement/disengagement was meaningless. It was siezed so tight that all of the engine power could be transmitted through it to the transmission regardless of clutch position. Jim Davis 87 Syncro 88 Wolfsburg
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.