Date:         Fri, 9 Feb 1996 20:27:15 -0500
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         DHaynes57@aol.com
Subject:      Re: Valve oil sealing rings.

In a message dated 96-02-09 00:46:18 EST, afn32620@freenet.afn.org (Aaron J.
Wood) writes:

>I am rebuilding a 1700cc pancake engine.  I looked in the Haynes 
>manual on how to put the valves back in and I noticed that it says to 
>put on new oil sealing rings aroung the valves.  The picture shows 
>something that lookes like a washer that fits onto the valve shaft on 
>the rocker side after the valve has been put througn the cylinder 
>head.  The problem is that when I took the engine apart there were 
>not any of theses rings on my valves.  Did only certain engines have 
>these?  Do I need to buy some? Is oil leaking down the valve guide a 
>problem with horizontal valves?  Thanks for any help.

The rings should be included in the engine gasket kit.  Most do not use them
as they do not do much f the giudes are not worn.  If used, they will quicky
crack and fall off and you will find them on the oil screen.