In my Bug, I had to pull off the speedo needle to remove the front cover plate of the speedometer. After replacing it ('errrr, that's about 0 mph..."), my indicated speed was 10 mph too high at cruising speeds. I wouldn't be surprised if Buses' are similar. Marking the needle/spindle would be the correct preventive action, but does any one know how to calibrate these things? Wait a minute, in the Bus, it would be easier: just attach the speedo to the cable under the dash and, while you match the speed of your friend's Bus, have a passenger stick the needle on at the agreed upon speed... OK, tell me, is this a bad idea ? +++ Morris Arthur < morris_arthur@unc.edu > +++ +++ Environmental Sciences and Engineering +++ +++ University of North Carolina +++
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.