Will the 'modified sine wave output' from the PCxxx series of inverters run 110v ac motors well, assuming amperage specs are acceptable? specifically, i wish to install a hot water circulating pump into the heating circuit of my wasserboxer for increased heater output. 12v models are available but i could buy a 110v model AND an inverter cheaper than just buying the 12v one. i have done this with a 12v Par Jabsco 'Centri Puppy' pump and was pleased with the result but the Jabsco pump seal didn't hold up to hot, pressurized anti-freeze. all replies appreciated. -dan
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.