Date: Tue, 12 Mar 1996 23:10:10 -0500
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: DHaynes57@aol.com
Subject: Re: Loose as a Goose
In a message dated 96-03-12 16:47:06 EST, jim@atcweb.atc.1dc.com (Jim Ellis)
writes:
>VanBondo sez:
>Replacement size of the reduction plate bolts is the metric 1.5 x 50 x 35mm
>length. Use matching sized thick wavy washers behind the bolts and torque
>them down to spec. I know the size because I just had to replace them on the
>'67 Westy Resto. Accidentily bought the 40mm length and they were too long.
>Forget the lock-tite (in my opinion)! Just find the correct torque spec and
>inspect them as you change the oil every three thousand or as needed. I
>paid about $.90 per bolt at PEPBOYS and saved many $$ and time in agony
>trying to get broken bolts out of the reduction box. I guess that if you
>have been driving on loose bolts then they have been buggered and could
>stand replacement. Do it right and do it once.
>-ellis\
In addition to the size of the bolts, the grade is important. Almost all el
cheapo bolts are grade 8.8 These bolts should be grade 10.9 or better. The
grade 8.8 will fail again.
Dennis.
|
Back to: Top of message | Previous page | Main VANAGON page
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives
@ gerry.vanagon.com
The vanagon mailing list archives are copyright (c)
1994-2011, and may not be reproduced without the
express written permission of the list administrators.
Posting messages to this mailing list grants
a license to the mailing list administrators to reproduce
the message in a compilation, either printed or electronic.
All compilations will be not-for-profit, with any excess
proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively
towards the management and operation of the Vanagon mailing
list and vanagon mailing list web site.