Date:         Mon, 18 Mar 1996 21:00:31 -0600
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         mbates@s3.sonnet.com (Marlin Bates, IV)
Subject:      Re: Engine Stands

How did you do this?  I am seriously very interested.

-Marlin

At 10:52 PM 3/18/96 -0600, Thomas Johnson wrote:
>At  9:53 PM 3/18/96 -0600, Marlin Bates, IV wrote:
>>Does any one know of a good source for an engine stand for a 1600 engine?
>>(Type I single relief)  About the cost as well?
>
>I made my own out of the bell housing off a '68 or later bus.  This has the
>added advantage of being able to bolt up a starter and bench test the
>engine.
>
>-Tom

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.