In a message dated 96-04-23 00:20:48 EDT, Grannegeer@aol.com writes: >I checked out the vac. lines and the operation of the solenoid, they all work >fine. It seems that the shaft is frozen or siezed. Does anyone have any >suggestions. This is a fairly common problem. To service, the trans has to be removed and the bell housing taken off. The assembly can then be removed by removing the roll pin that mounts the operating fork to the shaft. Then the operating mecanism can be removed for repair. Dennis.
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.