Date:         Mon, 1 Apr 96 11:05 WET
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Jack Bradley <bugman@lava.net>
Subject:      roller on bus door

        Just curious, but what are the tolerances supposed to be for
clearance between the top front roller on my sliding door (`70 bus) and the
rail in which it slides in?  When driving down the road it rattles pretty
hard when I hit a bump or whatever.  Is there supposed to be some kind of
bushing between the metal roller and the rail?  I'd say that there is about
1/8th of an inch on either side now.  I'm fairly sure that it would be safe
to say that it's well worn.. 

Jack Bradley
(bugman@lava.net)
http://www.lava.net/~bugman

`79 Triple Black SB conv.
`70 Westy

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.