Vanagon EuroVan
Previous (more recent) messageNext (less recent) messagePrevious (more recent) in topicNext (less recent) in topicPrevious (more recent) by same authorNext (less recent) by same authorPrevious page (April 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 8 Apr 1996 23:57:00 -0400
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         DHaynes57@aol.com
Subject:      Re: O2 Sens. Replacement

In a message dated 96-04-07 00:45:04 EDT, zumbrenn@ucsu.colorado.edu (ZUMBRENNEN JOSEPH CORY) writes:

>Hello all, > I found in the archives that there are generic 3-wire O2 sensors >available as well as some Bosch units that do not have the correct >connector and need to be spliced. There are 2 white wires and one black >one. How do you make sure that the white wires are correctly matched? Or >does it matter? Thanks in advance. > >

The white wires are for the heater. Polarity does not matter. If the sensor has three different colored wires as used on some Chrysler products, it will not work in the Vanagon. Dennis.


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.