Date: Tue, 28 May 96 18:40:44 UT
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: "Scott Allred" <Scott_Allred@msn.com>
Subject: RE: Re[2]: CB Performance Fuel Injection system
Jeff_Lorentzen@adventure.com wrote:
> Thanks for the reply, it's nice to hear from someone who actually has
> one. This sounds like their more expensive closed loop system. Do you
> have the cat. converter?
No I don't.
>
> My 1776cc is a type 1, I forget whether a 71 bus is Type 1 engine or
> Type 4. If type 1, did you have to modify the heads for a temp sensor?
> Any other engine mods or was it basically bolt on plus wiring and
> running fuel lines?
>
'71 is the last upright in a bus. I had to drill and tap the head for a temp
sensor -- next to the #4 exhaust so that the sensor is in the valve galley --
near the #4 exhaust valve spring.
Basically bolt-in. Biggest issues are where/how to mount things and where to
return fuel.
Fuel return - My first try at return was the defunct fuel vent -- bad move --
pressure build up cause gas tank leak. I now have it mounted in filler neck
and restored the vent system.
ECU - Under seat storage area.
MAP sensor - on fan housing
Fuel Pump - in engine compartment on l/h side with clamps.
> The new supply line is 1/2", is that ID or OD? Is the return line also
> 1/2"?
>
ID -- it's a big mother -- it goes into an in-line fuel pump ~1.5" diam. x 6 "
long. the outlet is 1/4" that runs to 3 & 4 injectors then to 1 & 2
injectors, then to a pressure regulator and finally returns to tank.
> I'm not that familiar with busses, is that mileage less, about the
> same, or more than stock?
>
Better than the Kadron's that I was using -- 14-15 city, 17-18 highway --
remember that this is an 1835 and a heavy camper (~3500 lbs) -- plus I pass
smog. I used to have to retrofit my old PICT to barely pass.
> Were the 48mm the only ones offered when you got it or did you chose
> them over the 40mm? Do the 48's seem about right for the engine or are
> they overkill for that size?
>
There all that were offered in duals. They do have a single center mount
throttle body -- don't know what size -- but I was told that what I have would
run best on my engine.
-Scott
'71 Westy, the Wayback Machine
http://coyote.accessnv.com/wayback