Volks, I need to know what the standard length of a valve adjusting screw is for a Type IV ('72 1700) engine is. I have measured mine at 26mm (a little over 1 inches for you metrically challenged :-)). If you have one out and about, please measure and report to me. Thanks in advance. Chris Vaughn Chris Vaughn '72 Westy
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.