Date:         Tue, 21 May 1996 16:00:52 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Ron Lussier <coyote@zuni.chaco.com>
Subject:      Re: new westy tent, '66 progress

At 02:07 PM 5/21/96 -0500, Dyer Lytle wrote:
>Today I bought a Westfalia accessory tent (The Drive-Away model with floor)
>and it brings up a question about tent poles.  Perhaps some of the people
>with tents have had a similar experience.  The tent looks good and all the
>poles but one seem to be in reasonably good shape.  That pole is one of the
>upper corner poles and is a little over-bent.  That is, the pole naturally has
>a bend in it of about 60 degrees or so but this one is bent about 75 degrees
>and there is a bit of a crease in the underside and very small cracks on
>the outside edges.  I need to straighten this and reinforce it.  Has anyone had
>any experience doing this?  What I though I would do would be to slowly bend
>it back to the normal angle, tapping the sides with a hammer to remove the
>crease, then weld the cracks closed and weld on a small, flat piece of metal
>for a brace inside the bend.  (The poles seem to be steel since my magnet
>sticks to it.) Other observations so far: This is a well made, *heavy* tent.

Hi, can I ask you a few questions about the Westie tent?

     1.  Where did you get it? :-)

     2.  Is this the tent with the yellow and blue 'racing stripes' on it?

     3.  If there is a part number on the tent, is it 216 010 433 045?

Thanks in advance!
Ron
--                                       
Ron 'Coyote' Lussier         /\_/\      ____             Chaco Communications
(408) 865-0657              (     )     \ _/__        10164 Parkwood Drive #8
coyote@chaco.com             \   /       \X  /       Cupertino, CA 95014-1533
(1990 VW Westfalia Camper)    \_/          \/    http://www.chaco.com/~coyote