Date:         Wed, 22 May 1996 09:59:45 -0600 (MDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Jack Reed <jackr@fortnet.org>
Subject:      Pushrod tube seal question

Hi All,
Part of my preventive maintenance chores for this year are to change out 
the (slightly) leaking pushrod tube seals on my 81 Westy, which I did 
this past weekend.  Noticed that there was lot of silicon sealant around 
the seals, but chalked that up to sloppy work on the PO's part.  Well now 
they leak MUCH BETTER than they did before and I'm wondering if there's a 
technique to this that I'm not aware of.  Any advice would be greatly 
appreciated as I plan on staunching the flow this coming weekend.
Jack

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.