Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sat, 25 May 1996 13:27:02 -0400
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         BusBoys@aol.com
Subject:      Re: failing engine mount?

Assuming you have checked the mounts on the rear engine cradle and the front transmission mount AND they all check out OK, the other possibility is the rear spring plate bushings. Shaped like a doughnut, these mount between the spring plate and the rear torsion bar. They could be possibly worn so much from movement that the spring plate itself is contacting the torsion bar housing and scraping it when the plate is moving. Sounds horrible and can make you think the whole rear is ready to fall out sometimes.

Jim / BusBoys@aol.com


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.