Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (May 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 10 May 1996 11:19:00 -0700 (PDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Maher, Steve (SD-MS)" <SMAHER@gi.com>
Subject:      Mystery Splittie Single Cab revisited

I just spotted the no-longer-mysterious Mystery Single Cab Splittie again where I work here, and picked up a few more details people asked me about.

The only things electrical on the back end of the bus, are the two little round flat taillights with chrome rims. No backup lights, no reflectors, no openings where other things should go. The rear hatch has a hole in the bottom center, which I at first took to be where the lock/pushbutton/whatever went to latch the hatch. But one listmember said that this '61 bus didn't come with a rear engine hatch lock or pushbutton (what *did* it come with there?); and another asked me if it had a crank handle aperture, to which I answered No. Now, however, I couldn't help but notice that this little hole in the hatch, was directly in line with the engine crankshaft. You don't suppose...???

The "table" inside the hatch, which is the first thing you take off when replacing the engine or muffler, has no corresponding hole. Maybe that piece isn't original? The 1600 DP engine, has no crank receptor, of course, but that means nothing.

The louvers on the rear quarters, on either side of the engine compartment, point out, not in. Also, the three louvers just behind the front cab doors, also point out.

The rear bumper is complete. The two vertical overriders, point straight up, just outside the hatch as it opens. There is one upper horizontal tube leading outward from the top of each overrider. They curve around the round corners of the bus and slope down, to meet the bumper ends at a 45 degree angle off vertical. The bumper is five pieces total-- the main beam that curves around both rear corners of the bus, the two vertical overriders, and the two tubes. Plus bolts&nuts of course.

Cool car. , , , , |\ |\ , |\ ____|\____________|\\_______________|________________|\______________|_____ ____|/__|________@__\|__|____O______|___|___@________|__|___|________|__|__ ___/|___|___|________|__|___|______@____|__|____@____|__|___|_______@___|__ __|_/_\_|___|_______@___|___|___________|__|___|____@___|___|___________|__ ___\|/__|___|___________|___|___________|__|___|________|__O____________|__ / O | Steve Maher smaher@gi.com '80 V6anagon '66 Mustang Coupevertible http://www.wp.com/IrishMafia "Gun control means using both hands!"


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.