> After trying everything from using the OEM filter to replacing the sending > units I bit the bullet and installed a VDO oil press. gauge. Low and behold >I > have an actual oil press. problem. After the van reaches operating temp. >the > gauge reads about 6-9 psi at idle and about 22 psi at highway speeds. This >is > after a so called reliable dealer assured me that the pressure checked out >at > 32psi.. Where did you install the VDO sender? I believe the placement of the sender can alter the reading by the gauge. The pressure as the oil leaves the pump will be higher than the pressure after it's finished it's lubrication route. Soooo, this maybe influencing your readings. I'm curious to hear the answer to this so keep me posted. James
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.