Back in the good old days, (so I've read) before timing lights, scopes and electronic gizmos, the method used to set timing was to test run over a section of road with a couple of handy marks about 1/4 mile apart. Approach first mark at 30 mph in top gear, floor it, measure time to next mark. Advance timing a little, repeat test, advance again and repeat until time decreases. Go back to last setting. If your sure that its not knocking even when you floor it at low revs and the temperature is normal then there should be no problem with advanced ignition timing. The object of advance as the revs increase is to enable the flame front of the exploding mixture to meet the piston as it passes top dead centre. As the conditions within the cylinder change (Throttle opening, effective charge volume, mixture etc) so the amount of advance required varies and the distributor centrifugal and vacuum advance mechanisms attempt to provide the optimum condition. This of course varies for every motor and so the factory setting is at best a good compromise. Knocking occurs when the compression provided by the piston and the compression due to the expanding flame front raise the pressure and temperature of the unburned mixture to the point of spontaneous explosion. This can be aggravated by glowing spots of carbon in the combustion chamber. The octane rating of the fuel, valve clearances , valve timing and exhaust system backpressures also affects the point at which the temperature and pressure cause it to ignite and hence the permissable advance. |From: Gregor Durstewitz | While adjusting the timing the other day I made a discovery I want to toss |out to y'all: It's an 1800cc\twin carbs engine, stock everything. Timing |according to manual is 10 deg. ATDC. That's the way I had it set until now. |I noticed though that it idles faster if I advance the timing a bit. So just |for the fun of it, I set the timing to 0 deg., and took it for a testdrive. |WHAT I NOTICED WAS THAT IT HAD A LOT MORE POWER THAT WAY. And I didn't |notice any knocking or overheating (I do have an oil temp gauge). To make a |short story long: I got scared I might screw up something anyways, and set |the timing back to factory specs at 10 deg. ATDC. So my question to the |list:
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.