Date: Mon, 24 Jun 1996 17:02:37 EDT
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: thorsland@bigvax.alfred.edu
Subject: Progress Report and Some More Questions
I pulled the "bad" head (left one) off of my '77 2L FI Westy engine last
weekend. The reason for my low compression is obvious. The #3 cylinder has
a burnt exhaust valve and the #4 cylinder has a loose intake valve seat. That
clears up my low compression problem. The bad valves along with a stripped
spark plug hole has made me decide to get a new head. The right head looked
fine. I also fixed my rough sliding cargo door last weekend. The spring thing
that pops the door out was broken so I replaced it with the one from my '73
donar bus/workshop. Now to my questions.
1. Where would you all advise me to get my new/rebuilt head? What companies
have you had good luck with in the past.
2. When I get my new/rebuilt head what will it typically come with. I assume
I will have to buy all the valves and rocker arms stuff separately (or use my
old stuff) is this true?
3. I also need new rings, new heater boxes, and a new clutch. Where should
I get these parts? (In your opinions)
4. Are there any other parts that are typically added that I should replace
while I have the engine out?
5. Has anyone had any experiance with the "BUSSTOP" and their garantee policy?
I believe that any part you order from them has a lifetime warrantee. Even if
you buy an exhast system through them and it rusts out is 5 years they will
replace it for free. Sounds good to me. I just want to make sure I know what
I am getting.
6. My girl friend's Uncle (truckdriver/mechanic) has offered to help me finish
my project (for a undisclosed amount of money). I would like him to help me
prepare the heads for use, prepare the cylinders for new rings, add the new
rings, put the engine back together, replace the clutch, and help me lift
the engine back into the bus. What would be a fair amount of money to offer
him for these services. Remember that I will be helping and he will be
hopefully teaching me how to do some of this stuff (this may add to the cost).
A general idea will be appreciated.
Thanks again,
Brett Thorsland