Date:         Sat, 22 Jun 1996 08:13:32 -0700
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Robert Crawford <robertc@snowcrest.net>
Subject:      Re: more oil temp

At 09:05 AM 6/22/96 -0500, e freeman wrote:
>one question:  where is the best place to put a temp sensor that doesnt 
>require case drilling or engine removal?  why would a dipstick sender be 

        On my 181 I have a temp sendor that screws into the same hole that
the oil pressure odiot-light uses I got it at my FLAPs and as I recall it is
a VDO part.
        Real easy instaliation 1.disconnect the wire from the existing oil
pressure sender (unplug the thing) 2. un-screw the sender from th engine 3.
screw the new sender in 4. plug in the oil pressure and oil temp wires 5.
start engine, watch it heat up.

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.