Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Jun 1996 17:39:01 -0500
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         bighouse@socomm.net (Ken Hooper)
Subject:      Re: Request for .009 timing measurments

>Does someone have the measurements [inches or cm] from 0 >on a stock-sized crank pulley for 7.5 and 30 BTDC? I seem >to remember 7.5" being about 3/8" to the left of 0.

Er, and those are to the right (FIF) of zero, not left. Of course they're the same on the left as well, if for some reason you don't want the plugs to fire until the piston's at the bottom of the stroke. ;)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.