Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (June 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 26 Jun 96 18:49:00 DST
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Easton Trevor <TEASTON@dqc2.dofasco.ca>
Subject:      Re: Request for .009 timing measurments

Be careful the crow doesn't get stuck in the fan or you'll have real temperature problems. ---------- |From: bighouse |To: Multiple recipients of list |Subject: Re: Request for .009 timing measurments |Date: June 26, 1996 5:37PM | | |>Does someone have the measurements [inches or cm] from 0 |>on a stock-sized crank pulley for 7.5 and 30 BTDC? I seem |>to remember 7.5" being about 3/8" to the left of 0. | |Measuring on a stock-sized degree wheel I never have installed: | |7.5 degrees = .45" or | 3/8" or | 11 mm | |30 degrees = 1.75" or | 1 3/4" or | 44 mm | |I'm measuring as the crow flies, not rolling around the diameter. | |--Ken | | |


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.