In a message dated 96-06-30 17:52:02 EDT, rnicholl@asg.unb.ca (Roy Nicholl) writes: << Does anyone out there have a 46mm axle nut for a '67 kombi/westy? I am beginning to think that I will have to cut this one off... Also, is there any chance that all this torking on the axle nut will damage the shaft/reduction box/ or trannie? >> What you want to buy is a striking wrench. This is a tool that allows you to use a breaker bar and a hammer to loosen extremely tight nuts. You can get these from Proto or KD. They are usually stacked at a local Graingers. This tool and a 5 lb lump hammer will get the nut off in no time. Dennis.
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.