Sounds like you've got a collapsed lifter.If you can push with your finger on the bottom of the rocker arm and it goes in then replace the lifter(they are about $10 ).Two turns in after zero clearance is correct..COLD! On Tue, 30 Jul 1996 Dmhoffmann@aol.com wrote: > Having replaced a broken rocker arm stud on my 1980 2. litre I proceeded to > adjust the valves. I tightened them to take out all play plus two full turns > of the the adjustment screw, but this was too tight, I lost compression in > cylinders. Then I redid it leaving the little play I felt in the Hydrolic > tappets, but leaving no gap between the adjustment screw and the valve stem. > Now they seem too loose. > 1. Should I be feeling a little play in the tappets at all? > 2. If so should I adjust it out? > 3. Should I do the operation hot or cold? > > Any help you could give would be most appreciated. Thanks, > > > > > > > > Doug > Hoffmann >
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.