Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (July 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Wed, 10 Jul 1996 17:49:37 -0500
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "R.D. Robertson" <rdr@arn.net>
Subject:      Question: '79 bus oil temp/pressure guage installation and wiring

Hey all,

I have VDO oil pressure and oil temp guages mounted in the rubber three-guage holder made by VDO. I've installed the senders, but have yet to install the guages or wiring to the cab. BTW, the oil temp sensor is mounted in the sump plate, the pressure sender in the normal oil pressure guage location in front of the distributor.

Where's a good place to mount the VDO rubber guage holder? What's the easiest/best way to run the two wires from the senders to the guages?

TIA,

Roy D. Robertson rdr@arn.net


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.