Date:         Sat, 3 Aug 1996 18:55:05 -0400
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Frank E. Terhaar-Yonkers" <fty@mcnc.org>
Subject:      Re: (headsup) wasserboxer cooling system failure dujour

I figured I couldn't be the only one ..

It's scary.  I just got back from a long drive, Raleigh to Atlanta
and back.  The damn thing could of come apart at any time. 
I "fixed" it by grinding the surface flush then slitting a piece of big 
radiator hose and wrapping the tube.  This and two hose clamps plus
a plug in the heater hose got me back on the road.  

I assume this thing is expensive.  So between now and late fall I need 
to fugure out if I'm going to replace it or find another way/place
to junction in the heater hose.  I'm leaning toward buying a piece 
of steel pipe, taping in a 1/4" nipple and putting the pipe inline 
with the big hose on the bottom of the unit.  Probably easier than 
replacing the dist. unit and a whole lot cheaper.

later - Frank

 >Yes, the distribution unit that you mentioned does seem a little frail.  
 >Mine did exactly the same as yours and broke off at the heater 
 >connection.
 >
 >The thing was a real pig to change also. Those one of a kind pipe clamps 
 >would not move easily.  Ended up breaking some of the other junctions 
 >off the unit in order to remove the pipes from the unit itself!
 >
 >You made a good point to KEEP AN EYE ON THIS PUPPY, it would leave the 
 >car in a dire hole if it were out in the middle of no where!!!!
 >
 >Sincerely,
 >
 >Chris Gibbs
 >88 Westie
 >

\\\\////\\\\////\\\\\////\\\\\////\\\\////\\\\////\\\\////\\\\////\\\\////\\\\
Frank Terhaar-Yonkers,  Manager
High Performance Computing and Communications Research
MCNC
PO Box 12889	3021 Cornwallis Road
Research Triangle Park,  North Carolina  27709-2889
fty@mcnc.org   voice (919)248-1417   FAX (919)248-1455

http://www.mcnc.org/hpcc.html