Date:         Fri, 13 Sep 1996 10:27:25 -0700 (PDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Steven Johnson" <sjohnson@pcocd2.intel.com>
Subject:      What prep/primer should I use?

Hi folks,

Well, I'm getting ready to install the Propex/Carver heater
under the bench seat in my '91 camper.  I have to drill a
couple of 1.5 inch holes through the floor which I will measure
at least twice and then think about it some more.  And then
after some more hemming and hawing will actually cut the holes.

What I need input on is how should I post prep the holes so they
don't start rusting.  Propex set some epoxy, but I don't think
that will cut it.  So if you folks can give me some good recom-
mendations, I'd really appreciate it.

Thanks,

Steven 
Sacramento, CA
sjohnson@pcocd2.intel.com

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.