Date:         Tue, 17 Sep 1996 23:51:53 -0400 (EDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         ERIC ZENO <emz@viper.nauticom.net>
Subject:      Re: Syncro Driveshaft Universal Joints 

On Tue, 17 Sep 1996, Todd Francis wrote:

> >
> >Have you actually done this? I was thinking about it butt when I looked
> into it I saw it was a pretty nasty job. I think a driveline shop would
> charge plenty.
> Todd Francis             tbf@pacifier.com
> '86 Westy Syncro         Vancouver, Wa
> '91 Tri Star Transporter
  
   Well I have a real edge. The company I work for does some of 
   the best machining around.  We build high accuracte motion
   equipment. The best in the world. Even Air bearing. So the 
   machining to me is free.

                    Eric Zeno

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.