In a message dated 96-11-21 20:09:38 EST, jag@cs.rochester.edu writes: << (*) I checked the front end for "tightness" by lifting the bus and trying to rock the wheel in all directions. Is there a better way to do this? >> The only way to test the ball joints is as follows: Lift front wheels a few inches off ground, Place pry bar between tire and ground Lift wheel with pry bar If any movement at all, lower joint is shot. They are available after market through Beck Arnley Dennis
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.