On Sun, 24 Nov 1996 DHaynes57@aol.com wrote: > In a message dated 96-11-23 03:08:30 EST, 1217@MN2.LAWSON.lawson.com (Paul > Holmdahl) writes: > > << > The transmission was just rebuilt on my 86 Syncro. Now, shifting is tight > from 3rd down into 2nd and down into 1st. Generally it is OK strating in > 1st and shifting into 2nd, though at times it's tight. Shifting up into > 3rd is tough sometimes, but it doesn't seem to follow a particular pattern. > > Is it possible the first two gears were not aligned correctly? >> > I had this problem in my 1980 Vanagon. Turned out to be the pilot bearing in the end of the crank shaft was bad. It would only cause a problem after the engine got hot. Eric Zeno
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.