On Sun, 17 Nov 1996, Gregory Mitch Daughtry wrote: > > How do you test this sensor? > -- > - Greg Daughtry - It's easy- remove the electrical connection from the sensor. Measure with an Ohm meter the resistance. At a given temperature you should measure specific Temps. temp. Ohms 212 200 194 250 176 300 158 400 140 600 122 775 104 1050 86 1500 68 2500 50 3500 32 5500 Measure cold. and check to air temp. Run the engine for 15 min. and check again. I should be in the 775 ohm to 200 ohm range. I found that it will run well even if its off by 300 ohms. Eric Zeno
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.