Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (November 1996)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Fri, 22 Nov 1996 16:36:41 -0800
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Tonya Pope <galba@premier.net>
Subject:      87 Help AGAIN

Hi again. Well, after 3 successfull trips, my vanagon decided to die again. Apparently the coolant temp. sensor didn't do the trick.

Latest: Yesterday after returning from Baton Rouge, van had been running the roads for about 4 hours, it kinda acted up. Stopped at DMV to turn in a license plate off Beetle, when I started the van back up, it idled rough and didn't like me touching the gas. I put it into drive and let it coast for about 10-15 yards. It then magically recovered and operated normally all the way to the post office. When I got back in the van and started it back up, it did it again, and again recovered after I put it in drive and coasted 10-15 yards. This was with a warmed up engine--guage had needle right over light where it normally is when warm. Behaved perfectly after each of these little episodes.

Today--Engine completely cold, start it up and it idles very rough. Actually it sounds good for about 2 seconds with rpm at 1000, drops rpms nearly dies chugs chugs chugs shakes rattles & rolls for 2-3 seconds, back to smooth 100 rpm for 2 seconds, shake rattle & roll, smooth, etc. Cycle continues until rpms drop too low and it kills. If I step on gas, it will increase rpms then shake rattle & roll & die. Tried putting it in gear and going up and down driveway to see if it would fix itself like yesterday, but it wouldn't.

List of what has already been done: NEW--temp. coolant sensor for FI, O2 sensor, air intake sensor, air intake boot, ignition coil, rotor, distributor cap, plug wires, vacuum lines, fuel pump, fuel filter, and has the air intake sensor harness as per technical bulletin installed. I've checked all the wiring twice already, but am going to do that again as well.

HELP!!!!!

Thanks everyone, Tonya 87 Vanagon GL (sick again) 74 S. Beetle (insuranceless, on the road to restoration)


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.