Date: Tue, 31 Dec 1996 14:23:08 -0700
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: "Michael A. Radtke" <m.radtke@elm.az05.bull.com>
Subject: RE: Q's about your cruise control installation
Sorry to bother the list with this, but my reply directly to Fred bounced.
I can't seem to send stuff to folks that have "%" in their addresses.
Perhaps someone with a stronger mailer can forward this to him since he
isn't reading the list.
Mike
----------
>From: Michael A. Radtke[SMTP:m.radtke@elm.az05.bull.com]
Sent: Tuesday, December 31, 1996 1:52 PM
To: 'Porter_Fred%PAX9@mr.nawcad.navy.mil'
Cc: JWALKER@UA1VM.UA.EDU; m.radtke@elm.az05.bull.com
Subject: RE: Q's about your cruise control installation
Fred,
1) It sounds like the Equus is a descendant of the cruise which I like
best. I have an AudioVox, not yet installed, that matches your
description. I have compared the hardware from the AudioVox with my
older cruises and it is an indisputable match. I suspect that Equus
is just another re-brand.
In my experience, this cruise is the best that I have ever installed.
It is the one that I installed on my '72 and '84 busses.
2) I don't have the AudioVox instructions available to me here at work,
so I can't comment on the ignition component warning. I am an
electrical engineer and I would take that warning with a grain of
salt. If radiation from your ignition system can affect the cruise at
more than a few inches, you have an ignition wiring problem. In other
words, your AM radio won't work either for the noise either. If you
have a problem with the cruise being erratic that you suspect is
ignition noise, the unit can be shielded with a piece of aluminum
foil. If that fixes the problem, then the permanent fix is new noise
suppresser ignition wires.
My bus installations were for a split unit ... servo and electronics
in separate boxes. I don't recall any ignition warning in my later
single unit installations, but the one on my '88 Mazda is about 8
inches from the coil.
In my '72, I put the servo under the floor near the gas pedal and let
it pull the throttle cable. My '84 is much more conventional with the
servo above the exhaust heat shield with a gentle 180 degree curve to
the throttle body.
3) I ran the control wires through the firewall and under the carpeting
up the left side of the bus. The situation may be different in Westy.
4) I don't recall the specific vacuum line. However, it should be in the
vicinity of the brake boost line. In other words, closer to the
engine than the throttle valve.
5) I have never needed any 'vacuum booster' with this type of cruise.
The cruise holds full throttle on hills steep enough for the bus not
to hold cruise speed.
6) As I mentioned above, I don't believe that electromagnetic
interference is an issue. In the worst case, a metal shield could
be installed. This balanced against the fact that the control cable
should only have gentle bends suggest that you would be better off
keeping the servo in the engine compartment.
Mike