>| where did you read that the coolant sender should be disconnected? I >| disconnect the idle stablizer, but I have never heard that anything >| else should be disconnected. In the Bentley. Though I just realized my timing instructions were for the digifant engine. Looking at the Bentley for the digijet, you are correct - the idle stablizer should be disconnected AND the two plugs should be connected together. That is all the connections that are specified in the Bentley (28.33). It also says that your idle speed should be adjusted before timing the ignition, and should be between 800 and 900 rpm. dave
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.