Date:         Fri, 31 Jan 1997 15:24:41 -0800
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         bayer@sybase.com (David Bayer)
Subject:      Re: timing settings...

>| where did you read that the coolant sender should be disconnected?  I 
>| disconnect the idle stablizer, but I have never heard that anything 
>| else should be disconnected.

	In the Bentley. Though I just realized my timing instructions were
for the digifant engine. Looking at the Bentley for the digijet, you are
correct - the idle stablizer should be disconnected AND the two plugs
should be connected together. That is all the connections that are specified
in the Bentley (28.33).
	It also says that your idle speed should be adjusted before timing
the ignition, and should be between 800 and 900 rpm.

dave

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!

Return to the archives @ gerry.vanagon.com

The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.