Date: Fri, 07 Feb 1997 23:22:38 -0800
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: Lawrence Johnson <ljohnson@halhinet.on.ca>
Subject: Re: propane leak?
Derato@aol.com wrote:
>
> now that ive had my 87 westy for several months now....ive tried putting
> propane in three times. each time is a different experience. the first
> time....put a pound ion just to check for leaks. lasted a few days....not as
> long as it should have based on how much i used it. the next time i added a
> puond....it lasted several months....about right for how much i used it.
> this last itme i figured all was well...and i would fill the tank(three
> pounds or gallons ). it was very cold outside...and once full and hose
> removed...the hissing began. i could see the vapor..or liquid propane coming
> out the fill valve. not where the propane goes in...but a littl hole to the
> left of fill, this went on for a while...i figueed it was over fulll...and
> was venting off overflow. the fill valve is a special type that only permits
> filling to 80%. i vented off more gas to speed up the process and the flow
> did slow down. finally it seemed to have stopped. unfortunately it didnt
> stop...and i could smell propane for days and days, until finally all the
> propane had leaked out. my question is...has anyone encountered this
> problem...and what was the solution? im wondering of the cold weather had
> anything to do with it...? have i noticed somthing about rebuilding the
> safety fill valve on the list? any input would be apprecciated. cant face
> the reality that my tank is rusted thru......since replacement is cost
> prohibitive. anyone made a conversion to another propane tank? or to the
> little one pound containers?
> derato
I have researched the possibility but have not yet made the connection
for an auxiliary propane tank. I bought a Propex furnace through Tom
Forhan and will be installing it as soon as the weather permits.
I found that the standard connection to a small 5 lb or 10 lb propane
tank consists of a flexible hose and regulator. The regulator end screws
into the top of the tank. The other end is what attaches to the Van
propane system.
This hose end is a female 3/8 45 degree flared coupling. I plan on
including in my Van propane plumbing system a 3/8 "T" (after the Main
Van valve and regulator) connected to an auxilliary 3/8 propane valve
(with a male 45 degree flared end). Whenever I want to connect an
auxiliary tank. I'll just screw the flex hose to the 3/8 flared valve,
open the Van valve and open the Tank valve.
Likewise when I want to connect some propane stove/lamp/BBQ, I can use
the same auxilliary Van valve coupling and use the Van propane tank.
Larry
'86 Syncro Westy