Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (February 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         01 Feb 97 13:38:43 EST
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         "Turner,Ronald L." <102660.66@CompuServe.COM>
Subject:      Re: Audi Turbo wheels on a Vanagon

>how different are the offsets? since some machining is required are the >offsets different or is the width/height of the rim different..

It bolts right on. The ONLY machining done to the wheel is the center hole - and that is machined out to clear the axle hub grease cap on the FRONT wheels. The rear wheels will bolt on fine without any machining, but I usually machine all for to ease in rotating the tires.

As I said before, you'll need a thin wheels spacer on the FRONT ONLY to keep the wheels from rubbing against the XXX (i have to check on the name of this part) though, it could be ground off a little, and eliminate the need for a spacer. I have seen it done both ways.

No spacers or grinding needs to be done on the rears, they sit right up flush against the drum.

>also, are these available in 14" with the correct bolt pattern?

Nope.

I prefer the 15"s anyway - if you run 205 60 15's, then the van sits at the exact same height as a regular 14" Vanagon wheel & tire.

If you run 65's, and 70's - then the height of road clearance will increase, without any rubbing.

chris


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.