Date:         Wed, 12 Feb 1997 00:00:38 -0330 (NST)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         Philip Menchions <pbj2003@infonet.st-johns.nf.ca>
Subject:      Water tank plate cover

 I'm replacing all the rusty looking screws on the three plate covers 
(it's a retentive thing). However,the two lower screws for the water tank 
plate cover,although they backed off no problem, are in a stubborn spot.
 
The "flap" which looks as if it should flip up doesn't budge, hence 
there's no way to remove the screws unless I drill out the holes which 
allow you to back off the screws in the first place to a larger size.
 
Perhaps the "flap" is seized ? Although I have the impression this is 
maybe just a flap in disguise made this way so it looks like the other 
two plate covers. Any ideas ?
 
Phil (all flapped out)
'89 Westy
 
P.S. Thanks all for the info on the P/S wires