Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (March 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Mon, 3 Mar 1997 20:09:55 -0800
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         bayer@sybase.com (David Bayer)
Subject:      Re: rear heater

>| After clamping both coolant hoses with a screw down clamp (can you >| imagine the vice grips popping off after hitting a big bump?) I removed >| the heater core and valve. The o-ring didn't have much "o" left, cross >| section wise; good reason for leak. The valve seems senescent, too. If it >| can't keep me from blowing air through it when closed, I'm sure that it >| can't hold back the coolant.

I recently did the same work, and found my valve didn't really close all the way. I assume this was designed into the vavle (though I don't really know of any pausible explanation). Is the valve supposed to actually close all the way?

dave


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.