I think that I am experiencing this same problem. If anyone has any ideas please post them to the list. Thanks. Cory '86 Westfalia On Sun, 20 Apr 1997, Bill Kenneke wrote: > I am having a heck of a time setting up my engine. If I set the > timing to specs (5 ATDC), the engine barely runs and will try to > stall after revving it. It will run fine above 2000 rpm but will > cycle from approx 400 - 1000 rpm at idle. The Hall unit checks out > okay, fuel pressure and flow volumeseems good, but I think that the > vacuum unit is not doing its job. Vacuum seems low at the fuel > pressure regulator unless above 2000 rpm. > > Any tips or advice from anyone (besides my wife's "Blow it up!"), > would be appreciated. > Bill Kenneke > '85 GL Camper > kenneke@clis.com >
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.