>About 18 months ago I had my clutch replaced with a new sachs unit. and >all was ok untill wendsday when it went south on me. The shop that has >the van now showed me the problem with the old clutch, the throw out >bearing did not match the pressure plate.. Is it possible that the other >shop tried to bluff there way through the instal by placing a beattle >t/o bearing with a vanagon pressure plate?? Actually, a Vanagon *does* use the same throwout bearing as a Beetle. -Ron Salmon The Bus Depot
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.