Chris, I don't know the arrangement of the aircooled blower assembly. But I changed mine from air-cooled without blower to water-cooled with blower. You easily disassemble the whole iron dashboard, I did it with the attached steering column because there are two screws I could not open. The dashboard is hold on 2 screws each side and some below the windshield. You can not disassemble the heater assembly without removing the dashboard. The wiring of the blower is not included but easily to add. You have to add the brown ground strip from the blower to the ground reference point left under the dashboard. The connector with the three yellow wires has to be attached to the fan switch and the red/black wire goes to a fuse terminal, I think it should be fuse#12. You may search the archives, there are some mails with additional information on this chapter. Helmut '80 Camper
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.