On Sun, 27 Apr 1997 11:38:16 -0500 Shawn & Janis Wright said: >Has anyone tried just measuring the static radius of the tire when >inflated this way? It would seem to me that taking an average of 3-4 >measurements on each tire, from ground to edge of rim, or centre of >axle, would indicate how close the front/rear radii are... the way i was always told to use in measuring the circumference of a tire (which would give you the radius/diameter easily) is to: - mark some spot on the side of the tire with masking tape. - put that taped spot next to the ground. - mark the spot on the ground (with a rock or something. best way would be to do this in a mall parking lot, off way back in the corner somewhere, where no one parks, and mark the pavement with some more masking tape) - now drive a straight line forward, slowly. counting each time the tape on the tire goes around and meets the ground again. count ten times and stop (with the taped spot on the tire again next to the ground). - mark THAT spot on the ground/pavement. - now measure the distance between the two spots on the ground/pavement and divide by ten. yeah, i know: it ain't "elegant" and it's a bitch in the rain. but it works! :)
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.