Vanagon EuroVan
Previous messageNext messagePrevious in topicNext in topicPrevious by same authorNext by same authorPrevious page (April 1997)Back to main VANAGON pageJoin or leave VANAGON (or change settings)ReplyPost a new messageSearchProportional fontNon-proportional font
Date:         Sun, 20 Apr 1997 20:55:47 -0400 (EDT)
Sender:       Vanagon Mailing List <vanagon@vanagon.com>
From:         aluscre@marconi.w8upd.uakron.edu (Anthony Luscre)
Subject:      low compression

Yesterday I was trying to set timing on recently acquired 80 Westy, but could not get it to run well. Points were good and I adjusted valves per manual. Still not running smooth and numerous backfiring. So I pulled plugs and ran compression test on all four cylinders #3 & #4 had 120 pounds #2 had 80 and #1 had zero. I am not sure of problem, any ideas out there... burnt valve?, head gasket?, cracked head?? Also can the head be removed without pulling engine?

Anthony


Back to: Top of message | Previous page | Main VANAGON page

Please note - During the past 17 years of operation, several gigabytes of Vanagon mail messages have been archived. Searching the entire collection will take up to five minutes to complete. Please be patient!


Return to the archives @ gerry.vanagon.com


The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.

Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.