Zeidler Helmut NTC/Dusseld. wrote: > Loose the rod clamp behind the fuel tank. -no problem > Set the leveler to idle between 3rd and 4th. -OK shifter in neutral > Set the gearbox to idle -Transmission in neutral > and pull the rod,which goes horizontally into the box, out of > the gearbox. -lengthen the rods to the trans. ------The manual says to center the stop fingers (the u shaped things at the end of the shifter) between the 3rd and 4th position in the shifter box, this should give the correct lenght of the rod. Been there done that. I just do not see how the shifter plate on the inside of the cab can also be adjusted. > Tighten the clamp. > > What I see on your failure report, you should > only turn the rods against each other. -you mean shorten the rod?
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.