All- Erik's note about a template for the roof vent (??) reminded me of a question I wanted to ask: A PO replaced the no-doubt hammered stock item with a 14" square RV type vent. The muttha' sticks up plenty high and the vehicle will never clear the garage door (even with the air out of the tires, I'll wager). Since it looks like the hole was enlarged to fit the new vent, there's little if any rational hope in returning to the stock piece in order to regain the clearance. Has anyone found an aftermarket vent that sits down a bit snugger on the surface? 'Course, if I never clean out the garage, I won't have to feel bad about not parking the vehicle in it! -Blaine
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.