Hello- I recently replaced the rear heater core in my 87 syncro. When I separated the valve and the core, there was no gasket between the two, nor was one included with the new core... I found that the gap between the two leaks when pressed from the side (like when I tried to put cover for the heater back on ;) ). Does anyone know if they is supposed to be an O-ring or gasket? Any recommendations on some gasket goo that will seal and set quickly? Thanks in advance... dave
|
Please note - During the past 17 years of operation, several gigabytes of
Vanagon mail messages have been archived. Searching the entire collection
will take up to five minutes to complete. Please be patient!
Return to the archives @ gerry.vanagon.com
The vanagon mailing list archives are copyright (c) 1994-2011, and may not be reproduced without the express written permission of the list administrators. Posting messages to this mailing list grants a license to the mailing list administrators to reproduce the message in a compilation, either printed or electronic. All compilations will be not-for-profit, with any excess proceeds going to the Vanagon mailing list.
Any profits from list compilations go exclusively towards the management and operation of the Vanagon mailing list and vanagon mailing list web site.