Date: Wed, 14 May 1997 17:56:04 -0500
Sender: Vanagon Mailing List <vanagon@vanagon.com>
From: Duane Teske <WeBJamn@mail.rkd.snds.com>
Subject: Re: Coolant Refill Bottle -Reply
>>> Katherine McElveen <mcelveen%onramp.net@internet.rkd.snds.com>
05/14/97 01:26pm >>>
>I've noticed that my coolant refill bottle seems to run dry, in the space of
>about a week. The engine was recently fixed for a colant leak and the
heads
>rebuilt.
>
>1.) Is loss from the refill tank normal?
>2.) Where do I check for leaks?
I have the same problem. As far as I know, all coolant leaks were fixed
and I STILL have a regularly dry overflow bottle. I'll be looking for
suggestions, too.
*********************************************************************
If the system has just been rebuilt, and there are no discernable leaks, my
guess is that there may be some residual air in the cooling system. I not
sure how you bleed the system properly -- it would seem the radiator way
up front makes a good air trap if it were to have been drained.
In any event, I would guess the air is slowly being purged from the system
as you drive -- being replace by coolant from the resevoir. So keep an eye
on the level and refill as necessary, and I would think the rate of "loss" will
diminish over time. It may take awhile, higher fluid velocities = higher
speed driving with front and rear heater valves open will speed the
process.
And if that isn't it, I had this problem: to the left of the resevoir is a plastic
expansion tank with a sensor in a recess on the top. In my situation, the
O-ring on the sensor deteriorated and allowed fluid to puddle in the recess.
Sometimes it stayed in the recess, sometimes it overflowed into the engine
compartment, but always on to a sheet metal shelf so you'd never see it on
the ground. In either case, it would evaporate over time so I'd never find
any wet spots. I eventually found it by looking at the system ( engine
compartment open) with the engine hot and running - under pressure you
could see the fluid being forced out. A new O-ring was a simple fix.
Good luck,
Duane Webjamn@snds.com
|